Just wondering if the RPM sensor for the G3X system will work with the single "dual" bendix mag?
Thanks,
Andy
I went over the install manual on the sensors, I'm sure the sensor would fit but not sure if it's compatible with my "dual" mag. Pic is top of my "dual" mag, top bleed port is just to the right of the red data tag.
I need to do some more research as to which side is the impulse, or if both are impulse mags. My mag has 4 bleed ports, 1 each in the middle of top and bottom and one in the middle of each side. Which port would I use?
Thanks,
Andy
I had much better luck using a UMA RPM Transducer connected to the
Mechanical Tach output shaft.
We have an O32H2AD engine
Did you try the Bedix Hall Effect sensor in the top center port of the dual mag? Was it unreliable?
Thanks
Unfortunately I don't think the Hall effect rpm will work with the bendix single dual mag unless I " machine " the mag case or sensor with a file.