mc607
Well Known Member
The measurements on page 18-10 are wrong and apparently they?ve been that way for quite a while. Following are the measurements that finally worked for me.
Vertical measurement on drawing 4.292, as built 4-5/32?.
Horizontal measurement on drawing 4.153, as built 5-5/16? measured to the outside radius of float clip. I had the float in the clip for the as built measurement but I did remove it when I did all the bends. I found that two duck bill plyers worked well for bending the wire.
Vertical measurement on drawing 4.292, as built 4-5/32?.
Horizontal measurement on drawing 4.153, as built 5-5/16? measured to the outside radius of float clip. I had the float in the clip for the as built measurement but I did remove it when I did all the bends. I found that two duck bill plyers worked well for bending the wire.