Rayh
Active Member
Yesterday I did my maiden voyage of my fresh built 12. I am not getting any fuel flow reading on the Skyview. I have the FL-60 red cube and set the k factor but it doesn't seem to be feeding the Skyview the fuel flow info. I checked voltage going to the cube and it is getting 12 volts. I removed it and there was no obstruction in it and I could see the impeller turning when I used my mouth to gently blew air toward the opening of inlet side of it. Any other ideas out there? I think the red cube might be bad. If so, I hope Van's can help me out with a replacement under warranty seeing that I have less than an hour time on this one.