I noticed some venting through one of my caps. I ordered both the large and small O-rings.
However the bottom plate on my cap does not turn to tighten. Its basically loose on the shaft. It’s not threaded and it appears the only way to tighten is via tightening the lock nut on the bottom.
I’m assuming that’s the way to tighten but thought so would ask before I head back up to the airport with the new O-rings.
However the bottom plate on my cap does not turn to tighten. Its basically loose on the shaft. It’s not threaded and it appears the only way to tighten is via tightening the lock nut on the bottom.
I’m assuming that’s the way to tighten but thought so would ask before I head back up to the airport with the new O-rings.