For those who have installed the LSE, did you install the magnets yourself and would you do it again?
I am somewhat concerned about getting the magnets located on the exact degree location, with the exact 20 degrees between them.
Am I wasting energy worrying about a nonevent as usual, or is there a legitimate concern here.
On one hand, being fairly skilled and very cheap, I hesitate to spend probably $125 shipping this wheel around. But on the other hand, I do not want to compromise the effectiveness of my $2300 ignition by being a degree off.
Trying to avoid stepping over a dollar to pick up a penny.
Thanks, Tim.
I am somewhat concerned about getting the magnets located on the exact degree location, with the exact 20 degrees between them.
Am I wasting energy worrying about a nonevent as usual, or is there a legitimate concern here.
On one hand, being fairly skilled and very cheap, I hesitate to spend probably $125 shipping this wheel around. But on the other hand, I do not want to compromise the effectiveness of my $2300 ignition by being a degree off.
Trying to avoid stepping over a dollar to pick up a penny.
Thanks, Tim.