Before I started trying to bend the canopy frame I wanted to get some thoughts on the best way to tackle this. The frame seems to naturally sit to the right before and after attaching the screws at the pivot point, Such that it is about 1/2inich off at the rear of the frame, left side not reaching the fuselage and right side overlapping. If I pull the frame to the left the overall frame is very close to be being the correct size, it just won’t sit in the correct place without me holding it there.
I can’t see what is pushing it to right - so the only thing I can think is to bend the right side in against the bow and open the left side out around the bow. I can’t see anything around the pivot point that pushes it one way.
Any thoughts before I start bending.
I can’t see what is pushing it to right - so the only thing I can think is to bend the right side in against the bow and open the left side out around the bow. I can’t see anything around the pivot point that pushes it one way.
Any thoughts before I start bending.
Last edited: