F-1069 side skin to bottom skin opening

[nbachert]

Did I miss in the directions how to fill the hole that is created just under the leading edge where the f-1069 side skins are bent up to the bottom skin? If not, how did you guys fill this opening? Thanks,

 

[AdamB]

If you mean the holes pointed to in this picture, then they are for aileron control rods
And fuel lines. They will be covered by the wings.

 

[Richard Connell]

I think he means this one. Yellow arrow.
I don’t think the fairing covers it so I’m curious too as I haven’t attached wings yet.

 

[nbachert]

That’s it

Yeah it doesn’t get covered by the wing or the intersection fairing. I put a piece of aluminum tape over them but I’m at a place where I can complete a permanent fix. I’m guessing glass over it, just wanted to make sure I didn’t miss something that was actually called out to do. Thanks

 

[AdamB]

Ah okay..

Not sure as I'm in the middle of the finishing kit and those holes are still open right now.

 

[lr172]

I filled with 3m HS repair filler (a stronger and more structural bondo). scuff the inside well and apply bondo from inside with a generous overlap on skin to create a secure plug. Then shape the outside with sandpaper, blending into the skin surface. You could also use epoxy/flox. If you don't care about the cosemetics, you could fill it with silicone after paint to stop the air intrusion.

Larry

 

[nbachert]

Thanks for the info.

 

[rdamazio]

I've seen several RV-10s (including the one built by Van's, shown at OSH) where they just left that open.