Edited post....
I had a question about the flatness of the elevator trim, but realized after posting, I was premature in measuring. The end I was concerned about not being flat was an end that I also had not bent the tabs over yet. I feel once I bend the tabs and join together, this will take out the slight bow I am seeing at this point. Will repost of that's not the case.
I had a question about the flatness of the elevator trim, but realized after posting, I was premature in measuring. The end I was concerned about not being flat was an end that I also had not bent the tabs over yet. I feel once I bend the tabs and join together, this will take out the slight bow I am seeing at this point. Will repost of that's not the case.
Last edited:
