Dynon SV-ADAHRS-200 wiring in RV-14

[BruceW]

OK, I feel stupid. I cant find the 9-pin out for the Dynon SV-ADAHRS-200 into the Vans WH-00012 ADAHRS harness.
Page 19-03 of the plans shows the Molex end and wire colors, just no pin numbers at the D-sub end.
Help appreciated.

OK, while Im at it, any tips for air tube routing/connections? (single ADAHRS install.)
Thanks.

 

[CF86301]

Look at the Left Wing page in https://www.vansaircraft.com/wp-content/uploads/2019/01/WH-00125.pdf .

Regarding other tubing and cable routing, you may find https://www.vansaircraft.com/faq-technical-builder-items/wing-wiring-routing-wires-in-the-wings/ useful. Some people like the flexible conduit Van's sells and the Sharkbite plastic suspension clamps that you can get from Lowe's and other places that you can rivet next to lightening holes and support the flexible conduit. But you seem to be an old hand, so you probably already knew that.

 

[BruceW]

Look at the Left Wing page in https://www.vansaircraft.com/wp-content/uploads/2019/01/WH-00125.pdf .

Regarding other tubing and cable routing, you may find https://www.vansaircraft.com/faq-technical-builder-items/wing-wiring-routing-wires-in-the-wings/ useful. Some people like the flexible conduit Van's sells and the Sharkbite plastic suspension clamps that you can get from Lowe's and other places that you can rivet next to lightening holes and support the flexible conduit. But you seem to be an old hand, so you probably already knew that.

THanks CF.
My mind is focused on sheet metal and aluminum, I didnt think of the overall wiring diagrams I saw long time ago.
Plus, does not help that wiring/electrical is not my favorite area.