BlackRV7
Well Known Member
OK, time to whine and cry. I had my carbon fiber panel made up a couple years ago. I already had my harness custom fabricated. Here is the quagmire. I have my 430 below my Dynon D10 (original product)directly above it. Well, this was all done prior to Dynon experiencing the breaking of squelch after hooking up the remote sensor. I opted to hold off until now, the last minute, of putting the forward deck on hoping someone would come up with a different arrangement than Dynon's ONLY fix, a 90 degree do hickey between the harness and the 21 pin connection. Well Dynon still ONLY has the 90 degree. This is of absolutely no use to me.
How close has anyone been able to get doing the calibration of the original D10 without the remote unit. Again, my harness is already made up using the D10 output, the D10A output will not work on my harness.
Dear Abby, Dear Abby:-(
How close has anyone been able to get doing the calibration of the original D10 without the remote unit. Again, my harness is already made up using the D10 output, the D10A output will not work on my harness.
Dear Abby, Dear Abby:-(