Michael Burbidge
Well Known Member
My Vans EGT gauge does not work. Not flying yet, but have done engine start. And after a few minutes the EGT gauge is still pegged at 0. The CHT gauge does work. These gauges are hooked to a single cylinder.
Here's what I've done so far:
1) Verified power and ground to the gauge.
2) Verified continuity in the sender wires between the gauge and the space connectors.
3) Verified that the sender wires are on the correct terminal on the gauge.
I'm not sure what to do next, but I would like to figure some way to determine if the problem is with the gauge, or the sender.
Any ideas?
Michael-
Here's what I've done so far:
1) Verified power and ground to the gauge.
2) Verified continuity in the sender wires between the gauge and the space connectors.
3) Verified that the sender wires are on the correct terminal on the gauge.
I'm not sure what to do next, but I would like to figure some way to determine if the problem is with the gauge, or the sender.
Any ideas?
Michael-