OK, after lots of good advise I went with #8 screws for the top of the cowl.
Next problem is that the cowl is too thin for a #8 countersink. I could build up the cowl along the top. Time consuming to get a nice job. Or I guess just c/sink it and accept oversize holes. Don't like that idea too much.
How have others dealt with this?
If you built it up how did you do it for a good finish/minimum hassle?
Next problem is that the cowl is too thin for a #8 countersink. I could build up the cowl along the top. Time consuming to get a nice job. Or I guess just c/sink it and accept oversize holes. Don't like that idea too much.
How have others dealt with this?
If you built it up how did you do it for a good finish/minimum hassle?