If all goes as planned tonight then I will finish my VS. Two questions; it has some light scratches and finger prints all over it. The construction manual suggests running some 600 grit wet sandpaper over it to get the scratches out, which I assume would clean it off a bit. Is this the suggested method or should I use a damp cloth to wipe it off... leave the scratches since in about 5 years when I'm done it will get blasted and painted anyhow?
For storage I was going to wrap it in some paper to protect it and put it on the shelve... concern if it gets moisture on the paper it might promote corrosion... best to just put it on a shelve as is and try my best not to hit it with anything?
Thanks!
For storage I was going to wrap it in some paper to protect it and put it on the shelve... concern if it gets moisture on the paper it might promote corrosion... best to just put it on a shelve as is and try my best not to hit it with anything?
Thanks!