Hi Folks,
I have two Cherry Max rivets to pull at the back end of the elevator bellcrank mounts that don't have sufficient clearance for a standard Cherry G28 hand puller head and there isn't sufficient access for an AD470 or screw/bolt and nut combination; so I'm stuck using a structural blind fastener. I did try a couple of pulls, but unfortunately, there isn't sufficient lateral clearance with the upright portion of the angle stock to permit a straight pull and the mandrel breaks off prior to becoming flush with the rivet head.
I'd appreciate any advice!
Thanks,
Vac
I have two Cherry Max rivets to pull at the back end of the elevator bellcrank mounts that don't have sufficient clearance for a standard Cherry G28 hand puller head and there isn't sufficient access for an AD470 or screw/bolt and nut combination; so I'm stuck using a structural blind fastener. I did try a couple of pulls, but unfortunately, there isn't sufficient lateral clearance with the upright portion of the angle stock to permit a straight pull and the mandrel breaks off prior to becoming flush with the rivet head.
I'd appreciate any advice!
Thanks,
Vac