Case vent

[Ron B.]

Would anyone know if the pipe fitting that the case vent rubber hose slips over (the one that screws into the block) comes with the engine or is it supplied with the kit. It's 3/4" NPT X 1" hose , or that's what it should be. Don't see it in the kit?
Ron

 

[jeffmoreau]

Fitting

I have a Superior engine and the fitting came installed from their factory.
I hope this helps you.
Thanks

 

[Ron B.]

Thanks Jeff
Mine engine is a rebuilt from Aerotec Engines and it has a AN 840 fitting with maybe a 3/4 " tube end. It's way too loose, and will have to be replaced. Anyone know if the 3/4"NPT X 1" tubing is a special fitting? I'm thinking of machining one out of alum.
Ron

 

[gasman]

Thanks Jeff
Mine engine is a rebuilt from Aerotec Engines and it has a AN 840 fitting with maybe a 3/4 " tube end. It's way too loose, and will have to be replaced. Anyone know if the 3/4"NPT X 1" tubing is a special fitting? I'm thinking of machining one out of alum.
Ron[/QUOT

YOUR LOCAL AUTO PARTS STORE WILL HAVE THEM........... MIGHT BE IN BRASS.

 

[Pilottonny]

On my IOX-320 (ECi-Titan, assempled by Dachsel Flugmotoren GmbH) it came installed !

Regards, Tonny.

 

[Ron B.]

I'd rather alum. and should only take a few minutes to make at the shop.

 

[GAHco]

Blue Goodies= Aluminum

The 90 degree Hose Nipple with 3/4" NPT and 3/4 Hose Nipple is AN842-12D

The 90 degree Hose Nipple with 3/4" NPT and 1" Hose Nipple is AN842-16D

http://www.gen-aircraft-hardware.com/images/pdf/ftgspcl.pdf