bill.hutchison
Well Known Member
Folks - trying to figure this out - getting better at fasteners for a non-builder but scratching my head a bit...
The aft end of my upper cowl is secured with these CamLocs as shown in the photo. I seem to have misplaced one in the shop and after quite some time of fruitless searching, I am trying to order a replacement.
I *think* this is p/n 04-03674 or 04-03675 on the AS website - https://www.aircraftspruce.com/pages/ha/fast_1camloc/sb-ss-studs.php
based on measuring the length of the stud - it's slightly longer than the .68 and slightly shorter than the .71....
Should I take another measurement? I'm not sure where to measure grip to figure this out.
And at nearly $7.00 a piece, I'd like to get it right when ordering a couple of spares....
Appreciate knowledge here. Especially if you tell me, no, dummy, this isn't a camloc, it's some-other-fastener....
The aft end of my upper cowl is secured with these CamLocs as shown in the photo. I seem to have misplaced one in the shop and after quite some time of fruitless searching, I am trying to order a replacement.
I *think* this is p/n 04-03674 or 04-03675 on the AS website - https://www.aircraftspruce.com/pages/ha/fast_1camloc/sb-ss-studs.php
based on measuring the length of the stud - it's slightly longer than the .68 and slightly shorter than the .71....
Should I take another measurement? I'm not sure where to measure grip to figure this out.
And at nearly $7.00 a piece, I'd like to get it right when ordering a couple of spares....
Appreciate knowledge here. Especially if you tell me, no, dummy, this isn't a camloc, it's some-other-fastener....