What's new
Van's Air Force

The definitive Van's Aircraft support community! Buying, building or flying an RV? Join our exclusive family of mentors and enthusiasts!

Baggage Floor Nutplate

J

joer308

Active Member
Patron
On Page 32-05, Figure 2, there is a nut plate, K1000-08D, around the access cover, with2 designations for attaching?

AN426AD3-3.5 and 2X CCR-264SS-3-2?

Why?
 

Attachments

  • IMG_0422.jpg
    IMG_0422.jpg
    1.5 MB · Views: 61
I think that is an alternative rivet if there is interference. It has been a while since I did that work..
 
If I remember right, it was impossible to get a squeezer in there and I wasn't going to make a custom bucking bar so a pulled rivet was the right answer for me. Remember, you're just trying to hold a nut plate in place and keep it from rotating while you install a screw. It's not critical.
 
You must log in or register to reply here.
Back
Top