AAflyer
Well Known Member
So, I'm meticulously fitting and trimming my baffles, with the idea of keeping them snug against the head covers, as much as possible. However, the cork gasket protrudes irregularly around each valve cover, causing concern.
I finally realized that I might like to remove the valve covers, and change gaskets, without removing my baffles.
So, my question is?Is this logical? Should I go ahead and grind the baffles to increase the gap around the valve covers so the baffles are completely clear( and then some) of the cork gaskets?
I finally realized that I might like to remove the valve covers, and change gaskets, without removing my baffles.
So, my question is?Is this logical? Should I go ahead and grind the baffles to increase the gap around the valve covers so the baffles are completely clear( and then some) of the cork gaskets?