Hi,
I came into my building process where I have to prepare the ribs by deburring and flueting them. I have seen some flueting youtube videos long time ago so I thought I know what I am doing.. So I attacked the 1st rib and here is the result! :
So is this reversible/fixable? I thought of ordering a new one but since I don't live in the US it will take few weeks to arrive at my door steps.
When I watched the videos again I new my mistake that I should do it light and gradually with checking each time
Also Another mistake I did with another rib (HS404) is this:
I think I accidently did that while filing the two notches in the aft flange. Can I just sand it? or is it a write off?
I came into my building process where I have to prepare the ribs by deburring and flueting them. I have seen some flueting youtube videos long time ago so I thought I know what I am doing.. So I attacked the 1st rib and here is the result! :
So is this reversible/fixable? I thought of ordering a new one but since I don't live in the US it will take few weeks to arrive at my door steps.
When I watched the videos again I new my mistake that I should do it light and gradually with checking each time
Also Another mistake I did with another rib (HS404) is this:
I think I accidently did that while filing the two notches in the aft flange. Can I just sand it? or is it a write off?