PaulvS
Well Known Member
AOA port in wing skin (4/6/7/8 wing profile)
I'd like to fit an AOA port in the wing skin for my RV-6A, similar to the way it's done on the RV-12 using a pop rivet, for Dynon AOA. I already have the Vans pitot fitted and don't really want to use the Dynon combined pitot/AOA mast.
Can anyone confirm the position where the pop rivet should be fitted relative to the leading edge?
There is another thread that described this for an RV-4 but I'm hoping to get some more data points before drilling any holes.
https://vansairforce.net/community/showthread.php?t=186185&highlight=aoa+rivet
Thanks!
I'd like to fit an AOA port in the wing skin for my RV-6A, similar to the way it's done on the RV-12 using a pop rivet, for Dynon AOA. I already have the Vans pitot fitted and don't really want to use the Dynon combined pitot/AOA mast.
Can anyone confirm the position where the pop rivet should be fitted relative to the leading edge?
There is another thread that described this for an RV-4 but I'm hoping to get some more data points before drilling any holes.
https://vansairforce.net/community/showthread.php?t=186185&highlight=aoa+rivet
Thanks!
Last edited: