Stockmanreef
Well Known Member
Before I move ahead I just want to make sure that I am doing this correctly. It says to mating counter sink the trailing edge. At this point, I think that is the the wedge shaped part and not the trailing edge skin. I assume that the "trailing edge" gets countersunk, then the trailing edge of the skin gets dimpled.
I have already counter sunk the wedge piece. Before I dimple the trailing edge of the skin, I wanted to make sure.
Maybe this is clear in the plans, but IMO it is not crystal clear.
Thanks
Ken
I have already counter sunk the wedge piece. Before I dimple the trailing edge of the skin, I wanted to make sure.
Maybe this is clear in the plans, but IMO it is not crystal clear.
Thanks
Ken