I'm finally doing final install of the AS quad armrest and finding the fore/aft position on the tunnel cover.
There is a small lip - approx 1/16-1/8" x 3/32" on the inside bottom of armrest flanges on both sides. It runs the length of the armrest and makes it difficult to align the bottom of the armrest with the bottom of the tunnel cover.
Did you all sand this flat so the bottom inside edges of the armrest sit flat against the tunnel cover? Seems like a rookie question but I wanted to make sure I'm not missing something before I sand the lip off.
Thx.
There is a small lip - approx 1/16-1/8" x 3/32" on the inside bottom of armrest flanges on both sides. It runs the length of the armrest and makes it difficult to align the bottom of the armrest with the bottom of the tunnel cover.
Did you all sand this flat so the bottom inside edges of the armrest sit flat against the tunnel cover? Seems like a rookie question but I wanted to make sure I'm not missing something before I sand the lip off.
Thx.
