Ok... so as I was finishing riveting all the fuselage bulkheads together today... I unfortunately slipped on one of the rivets!
A nice little ding from the rivet set appeared on the bulkhead #3 flange as a result!!
Now, my question is... leave it as is or
#1--> De-rivet it all and build a doubler and rivet again...
#2--> Drill bigger size and put a bigger rivet..
#3 --> Or again, leave it as is because the fuselage is held together with the skin and j-stringers and it probably will never crack... also add this to my condition inspection as a "danger" point!?
What would you recommend?
Thanks
A nice little ding from the rivet set appeared on the bulkhead #3 flange as a result!!
Now, my question is... leave it as is or
#1--> De-rivet it all and build a doubler and rivet again...
#2--> Drill bigger size and put a bigger rivet..
#3 --> Or again, leave it as is because the fuselage is held together with the skin and j-stringers and it probably will never crack... also add this to my condition inspection as a "danger" point!?
What would you recommend?
Thanks