Hi Guys,
I'm trying to have the Vans rear spinner bulkhead assembly not touch the Hartzell C2YL-1BF/F7663-4 C/S prop when I have it FULLY rotated(no oil in there) Prop manual discusses no more than three AN90-416(.063") washers in their proper positions as well as spacers. I infer from the DWG C4 that 4X spacers means one for each of the AN6-43A bolts.
Well, for the prop not to touch the rear bulkhead, I need two spacers and a thin washer(.452" total) which allows for maybe one thread showing through the nut and that is with another thin washer on the nut side.
What is wrong here?
I'm trying to have the Vans rear spinner bulkhead assembly not touch the Hartzell C2YL-1BF/F7663-4 C/S prop when I have it FULLY rotated(no oil in there) Prop manual discusses no more than three AN90-416(.063") washers in their proper positions as well as spacers. I infer from the DWG C4 that 4X spacers means one for each of the AN6-43A bolts.
Well, for the prop not to touch the rear bulkhead, I need two spacers and a thin washer(.452" total) which allows for maybe one thread showing through the nut and that is with another thin washer on the nut side.
What is wrong here?