claycookiemonster
Well Known Member
The previous builder of my project went to the trouble of installing nutplates beneath all of the floor panels. However, the nutplates do not extend into the floor of the baggage compartment. I can nest the baggage compartment floor beneath the cockpit floors and screw the leading edge of the baggage floor along with the main floors. Is there anything to be gained by continuing the nutplates beneath the floor of the rear baggage compartment up to the point where the rear wall of the baggage compartment goes vertical over the battery?
Anything I'm going to need to access down there?
Also, the thin cuts in the sides of the left and right rear floors, where they go around the reinforcements over the rear spar attach points do not fit exactly right. Any issue of widening the opening of that cut by 1/16" to 1/8" so it's not pressing on that bulkhead?
Anything I'm going to need to access down there?
Also, the thin cuts in the sides of the left and right rear floors, where they go around the reinforcements over the rear spar attach points do not fit exactly right. Any issue of widening the opening of that cut by 1/16" to 1/8" so it's not pressing on that bulkhead?