claycookiemonster
Well Known Member
I'm struggling to get the control throws at the throttle quadrant to equal (or slightly exceed) the throws needed at the engine. The mixture arm as delivered needs a throw of 2.5" or even a bit more, and that's just about impossible to achieve at my quadrant. The hole required on the mixture arm will be so high that the cable will rub against the bottom of the bolts holding the quadrant together.
However, the control arm seems to have a suspiciously open area closer to the center where I could achieve full travel of the arm with reduces cable travel. I could drill a new hole there and proceed.
Is this legit? Legal? Safe? Reasonable?
However, the control arm seems to have a suspiciously open area closer to the center where I could achieve full travel of the arm with reduces cable travel. I could drill a new hole there and proceed.
Is this legit? Legal? Safe? Reasonable?