oren_rokach
Well Known Member
Hi folks
I am using momentary switch to toggle between predefined flaps predefined points.
Only after I cross 10 deg, the toggling works. To reach 10 deg flaps,I need to constantly press the "down" button.
after reaching it, i can toggle down or up freely.
I would expect a single "down" to reach 10, another to 20 and another to 30
is this a known issue?
What is the - (minus) good for?
Can anyone share its calibration table?!
Thanks!
Oren
I am using momentary switch to toggle between predefined flaps predefined points.
Only after I cross 10 deg, the toggling works. To reach 10 deg flaps,I need to constantly press the "down" button.
after reaching it, i can toggle down or up freely.
I would expect a single "down" to reach 10, another to 20 and another to 30
is this a known issue?
What is the - (minus) good for?
Can anyone share its calibration table?!
Thanks!
Oren