Good afternoon all. I am getting ready to cut the aft flange of the top cowl, big thanks to Dan H for his post on fitting the 2 halves together.
When I set the top cowl to spinner gap at 1/4" at the top of the spinner, the sides end up close to .100" greater distance. Is this normal? It seems impossible to get 1/4" spacing around the entire circumference of the spinner. I am planning on 1/8" engine sag.
Any advice would be much appreciated.
Trevor
When I set the top cowl to spinner gap at 1/4" at the top of the spinner, the sides end up close to .100" greater distance. Is this normal? It seems impossible to get 1/4" spacing around the entire circumference of the spinner. I am planning on 1/8" engine sag.
Any advice would be much appreciated.
Trevor