Seeking assistance from fellow builders on fitting the inboard and outboard filter mounts vs the snorkel.
Instructions say to cut the VA-132-1A in half to make 2 parts.
6 1/8 inch each, then trim a 1/4 inch on one flange.
Thus, this results in a 5 7/8 inch long flange while the snorkel is 5 1/4 inch on that side.
Am I missing something?
Should I trim another 5/8 to match the snorkel's dimension??
I ask as I don't want to mess up these 2 parts, (as I messed up the lower left air ramp, following the baffles instructions before reading these instructions where it says to NOT trim that part before installing the snorkel...)
Also, the top view of the 3 filter mounts doesn't make sense to me.
The mounts don't seem to have that relative position one another once fitted to the snorkel...
????
Instructions say to cut the VA-132-1A in half to make 2 parts.
6 1/8 inch each, then trim a 1/4 inch on one flange.
Thus, this results in a 5 7/8 inch long flange while the snorkel is 5 1/4 inch on that side.
Am I missing something?
Should I trim another 5/8 to match the snorkel's dimension??
I ask as I don't want to mess up these 2 parts, (as I messed up the lower left air ramp, following the baffles instructions before reading these instructions where it says to NOT trim that part before installing the snorkel...)
Also, the top view of the 3 filter mounts doesn't make sense to me.
The mounts don't seem to have that relative position one another once fitted to the snorkel...
????