Seeking some advice. Building a 9A and the landing gear is 2nd hand. The bolt is loose in the main weldments, not bad but loose . A 8 mm bolt takes up all slack. The standard bolt is good going in, but loose coming out the hole. This is for the gear leg. I assume I would have to step up to the oversized AN bolt for this which would require reaming the gear leg and weldment. Also I’d like to do the taper pin mod to the front leg. So, would the very expensive taper reamer do for both the front and the mains if I taper pined the mains also? Thank for your input.