FlyingDiver
Well Known Member
Built my first work table for the shop, according to the EAA 1000 plans. Came out pretty good, but with a slight wobble. One of the legs is maybe 1/16" long, probably because of a slightly warped 2x4. Or maybe I mis-cut. Who knows?
Anyway, what's the best way to trim a leg? I was thinking of getting a coarse sanding disk for my angle grinder. Any other suggestions?
joe
Anyway, what's the best way to trim a leg? I was thinking of getting a coarse sanding disk for my angle grinder. Any other suggestions?
joe