While dimpling away on the VS Skin, I got a little excited and with about 6 holes left, dimpled one of the holes on the bottom the plans say to not dimple. Not to be stifled by this, I decided I was going to pound it back with my rivet gun. In a additional stroke of brilliance, I decided to use a bucking bar on top of the dimple. This caused a small crease, I want to say less then 2 inches long. It doesn't seem to bad, but im curious if I should replace the skin
I don't think its blatantly obvious that is there, but if I look for it, I can see it
I don't think its blatantly obvious that is there, but if I look for it, I can see it