View Single Post
  #1  
Old 03-05-2013, 11:44 AM
crabandy crabandy is offline
 
Join Date: Jan 2010
Location: Ottawa, Ks
Posts: 2,399
Default Engine mount to terminal clearance

It's not what I envisioned when I put the anl/shunt on the firewall, but before I make anymore wires I wanted to check with VAF. The anl/ shunt is on the right (copilot) side of the firewall about halfway top to bottom. The top nut of the shunt is 1/8 inch from the engine mount tube. The wires and terminals 1/4 inch away.


I was going to put a rubber boot on it and no amount of firewall flexing will make it touch. In a crash it could bend and touch but the master and alt should cut power. Is it too close and I should move it or it is fine and build on?
Reply With Quote