WingedFrog
Well Known Member
I was pretty satisfied of the quality of my riveting on the Upper Hinge Assembly, until a fellow EAA member pinpointed the gap at the opposite side of the riveted area. Here is the picture:
http://tiny.cc/x3vcc
My question: is the gap shown acceptable or should I rework this part by removing all rivets?
Note that I am aware that the assembly needs some polishing on the side but it was deburred
http://tiny.cc/x3vcc
My question: is the gap shown acceptable or should I rework this part by removing all rivets?
Note that I am aware that the assembly needs some polishing on the side but it was deburred