i have started working on cleaning, flutting wing ribs. I also intend to install landing lights, strobe and nav lights. I went through FAQ that VANS published regarding wing wiring and this is what they begin with:
"There are a number installations that require routing of wires and tubes in the wing. These may include nav lights, strobe lights, landing lights, heated pitot, nav antenna, autopilot, AOA and maybe a stall warning device. Listed here, in no particular preference, are some ways to run wires and tubing through the wing ribs. "
I am confused about the autopilot part. I intend to install autopilot and now i am wondering if i have to do something now for the autopilot? also they mention that we can drill a #30 hole near the lighting hole to hold the wire conduit with a wire tie. Anyone has done this and have a picture i can take a look at i would appreciate it.
"There are a number installations that require routing of wires and tubes in the wing. These may include nav lights, strobe lights, landing lights, heated pitot, nav antenna, autopilot, AOA and maybe a stall warning device. Listed here, in no particular preference, are some ways to run wires and tubing through the wing ribs. "
I am confused about the autopilot part. I intend to install autopilot and now i am wondering if i have to do something now for the autopilot? also they mention that we can drill a #30 hole near the lighting hole to hold the wire conduit with a wire tie. Anyone has done this and have a picture i can take a look at i would appreciate it.