jamcgee1978
Active Member
Hi all from a chilly scotland,
So the time has come to enlarge holes for the wire run for the lights & pitot lines. As the ribs come with 2 pre-punched holes my plan was to:
1) enlarge hole furthest from spar to 3/4 for conduit for wire run to lights
2) enlarge hole closest to spar to 7/16 for SB437-4 bushing for pitot
I have seen others have created 3 holes, one for the conduit and 2 for the AOA/PITOT . As i have held off purchasing any electrics yet its hard to visualise what wires will go were and how many i?ll need to pass through
Are there tried and tested methods when it comes to locations for wiring (interference etc) that i need to consider?
Any advice more than welcome before i goto town with my unibit,
Thanks
James
So the time has come to enlarge holes for the wire run for the lights & pitot lines. As the ribs come with 2 pre-punched holes my plan was to:
1) enlarge hole furthest from spar to 3/4 for conduit for wire run to lights
2) enlarge hole closest to spar to 7/16 for SB437-4 bushing for pitot
I have seen others have created 3 holes, one for the conduit and 2 for the AOA/PITOT . As i have held off purchasing any electrics yet its hard to visualise what wires will go were and how many i?ll need to pass through
Are there tried and tested methods when it comes to locations for wiring (interference etc) that i need to consider?
Any advice more than welcome before i goto town with my unibit,
Thanks
James