My 14A has wires in the harness for the rear AeroLEDs position/anti collision light. But, the wires in my harness don't match the plans. Plans show five wires going to aft end of VS where the light lives: white/orange, white/blue, white, green, and black. My harness has everything except the green. Plans show the green wire going from aft fuse to a 12 pin molex mounted on a forward bulkhead connecting to position No. 9. My harness has no wire connected to No. 9 on this molex. Also, my harness has the black wire at the aft light location with a female molex pin connected and grouped with the other three wires (as though it is intended to connect to the molex on the light). But this black wire loops back from where the molex will be as though intended to be connected to ground at the fuse.
I don't have the entire wiring diagram for the plane, so difficult to troubleshoot. My sense is the white/orange and white/blue are switched power and that the white is a sync wire, but not sure about this.
Any help appreciated.
I called Van's but they weren't sure why the harness didn't match the plans. Unusual.
I don't have the entire wiring diagram for the plane, so difficult to troubleshoot. My sense is the white/orange and white/blue are switched power and that the white is a sync wire, but not sure about this.
Any help appreciated.
I called Van's but they weren't sure why the harness didn't match the plans. Unusual.