Wing Dimensions

[Wyzepilot]

Good morning all,

I plan on ordering the QB wing kit this winter and am trying to figure out if I can squeeze it down into my basement workshop. My horizontal Stabilizer fits in and out without too much difficulty and I'm hoping I can build the wings down there as well. I only have a one car garage and am trying to save that for the fuselage. If anyone has the dimensions of each wing, span and chord, that would be very helpful. Thanks!

Dave

 

[[email protected]]

Don't have dimentions with me but

I think they are roughly 11' by 4.75' or so by my guesstimate. (no control surfaces)

I think they would easily fit up a set of basement stairs as long as you have a straight shot before and after.

 

[dspender]

I just measured them at a builders site in Canton Mi last weekend. The quickbuild wings, which I have ordered as well, measure 12'5" from inboard end of spar to outboard rib. I didn't measure the width (fwd to aft) but they look to be about 4 ft.

 

[Wyzepilot]

Great? Thanks for the info gentlemen.