Hoping Dynon support can help me here or possibly a forum member that had the same issue. I have a D100 and D120 connected via DSAB. Both are configured to turn on/off based upon 12VDC input. The D100 has a B/U Batt and D120 does not.
When I turn off the Master Switch, the D120 shuts down as expected, but The D100 stays running on the battery and gives me a DSAB error. I suspect the error is interuppting the shutdown command and taking priority.
Is there a way to configure it to shut down without manual intervention on loss of 12V. I am afraid that one day I am going to forget the manual shut down and drain the B/U Batt. I would expect this to operate like the Garmin 396, which tells me there was a power loss and will shut down in xx seconds unless I press a button. In fact, I thought I have seen it do this when I don't get the DSAB error, but it has been a long time; probably during installation before networking them together.
Thanks,
Larry
When I turn off the Master Switch, the D120 shuts down as expected, but The D100 stays running on the battery and gives me a DSAB error. I suspect the error is interuppting the shutdown command and taking priority.
Is there a way to configure it to shut down without manual intervention on loss of 12V. I am afraid that one day I am going to forget the manual shut down and drain the B/U Batt. I would expect this to operate like the Garmin 396, which tells me there was a power loss and will shut down in xx seconds unless I press a button. In fact, I thought I have seen it do this when I don't get the DSAB error, but it has been a long time; probably during installation before networking them together.
Thanks,
Larry