Hey all,
I'm installing my cowl and it looks like I've yet again created some extra work for myself
The whirlwind RV10 carbon spinner has a nice angle on it that is, unfortunately, different from the angle on the RV10 cowl.
Here's the interference I'm seeing:
I'm trying to create the 1/8" gap while letting the cowl sag slightly below the spinner, but the interference above is preventing this.
Should I just sand the Vans cowl far back until I can get things to fit and then rebuild later? Or with this spinner do folks just cut the lip off?
Thanks!
I'm installing my cowl and it looks like I've yet again created some extra work for myself
The whirlwind RV10 carbon spinner has a nice angle on it that is, unfortunately, different from the angle on the RV10 cowl.
Here's the interference I'm seeing:
I'm trying to create the 1/8" gap while letting the cowl sag slightly below the spinner, but the interference above is preventing this.
Should I just sand the Vans cowl far back until I can get things to fit and then rebuild later? Or with this spinner do folks just cut the lip off?
Thanks!