On page 14-03 it says to make the W-1025A flap hinge brackets flat. Two of mine were very nearly flat on arrival so a little adjustment and I'm satisfied. The third and fourth ones have complex bends in them. One I got very nearly flat and am satisfied. The fourth one though I can't get it there - it won't lay table flat.
But - it is within 1/32" end to end. Is that flat enough? I asked Vans yesterday but haven't heard yet. I've spent a lot of time on it getting it that good. If it isn't good enough I'm thinking of ordering another and trying to hope I get a better one next time.
But - it is within 1/32" end to end. Is that flat enough? I asked Vans yesterday but haven't heard yet. I've spent a lot of time on it getting it that good. If it isn't good enough I'm thinking of ordering another and trying to hope I get a better one next time.