I am building my upper FWD fuse assembly. I know some folks have modified the ribs to allow more avionics room. Van's recommended building it as is and waiting until the boxes are at hand before doing any mods.
I seems to me that it will be a lot easier to do now in the construction phase rather than later. I was planning on using the side skin roll angles which are now scrap to reinforce the cutout.
I am planning an all EFIS panel either GRT or Dynon.
Should I mod now or build as designed and take my chances later?
I seems to me that it will be a lot easier to do now in the construction phase rather than later. I was planning on using the side skin roll angles which are now scrap to reinforce the cutout.
I am planning an all EFIS panel either GRT or Dynon.
Should I mod now or build as designed and take my chances later?