Good afternoon all. I am looking for a little guidance on installation of the upper cowl inlet ducts. I have engine installed, cowls fit, baffles finished. Basically firewall forward is complete minus these ducts and the oil door. How are these ducts supposed to fit with the baffle seals? As things stand now the baffle seals the top cowl, so are the seals supposed to seat under the ducts? Or, should I fit the ducts, glass them in then trim my baffles to match the duct installation? Looking at others photos the forward part of the baffles have been cut down much more than mine.
Time to sit back and have a beer. Usually that helps, but if anyone can point me in a direction that would be great!
Trevor
Time to sit back and have a beer. Usually that helps, but if anyone can point me in a direction that would be great!
Trevor