Van's Air Force
The definitive Van's Aircraft support community! Buying, building or flying an RV? Join our exclusive family of mentors and enthusiasts!
Tunnel harness
- Thread starter Platyius
- Start date
Check the revisions
One of the cables was left out of the original instructions, but was in the picture. Include page number and step if possible. I don't recall any cable being involved with a D-sub connector, unless you are indicating it leaves the harness at that point. That is the one they missed originally as I recall.
John Bender
One of the cables was left out of the original instructions, but was in the picture. Include page number and step if possible. I don't recall any cable being involved with a D-sub connector, unless you are indicating it leaves the harness at that point. That is the one they missed originally as I recall.
John Bender
MartySantic
Well Known Member
The two coaxial cables do NOT get inserted into either of the D-sub connectors. One of the coaxial cables was not mentioned in the original plan revision but has since been corrected via a revision that is available on the "revisions page".
Wire
Can't get to my panel right now, but i have a drawing that shows the wire on pin 21. It is a single conductor shielded cable with the shield grounded on pin 26. Wire is no. F55 and goes to the ELT on right side behind passenger seat. Page 31-05 step 4.
Can't get to my panel right now, but i have a drawing that shows the wire on pin 21. It is a single conductor shielded cable with the shield grounded on pin 26. Wire is no. F55 and goes to the ELT on right side behind passenger seat. Page 31-05 step 4.
Last edited:
dick seiders
Well Known Member
wire question
What page and wires are you all talking about?
Dick Seiders
What page and wires are you all talking about?
Dick Seiders
