aviationgeek84
Well Known Member
Hi All,
I am getting ready to trim my HS-710 and HS-714 pieces for my front spar on the horizontal stabilizer. Is there a "better" way to go about doing this to get consistent results on both other than the info Van's provides in the instructions and plans?
I did measure out the 3 3/8" called out in the plans (see photos) and note that 1/4" radius marked on the plans as well. I've attached the photos of what I'm looking at. Just looking for tips/tricks.![Smile :) :)](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
Thanks!
I am getting ready to trim my HS-710 and HS-714 pieces for my front spar on the horizontal stabilizer. Is there a "better" way to go about doing this to get consistent results on both other than the info Van's provides in the instructions and plans?
I did measure out the 3 3/8" called out in the plans (see photos) and note that 1/4" radius marked on the plans as well. I've attached the photos of what I'm looking at. Just looking for tips/tricks.
![100_1632.jpg](/proxy.php?image=http%3A%2F%2Flh3.ggpht.com%2F_7TR0_ivhXKY%2FSvdxu4PgBxI%2FAAAAAAAAHSg%2F_z78wkOZxIk%2Fs400%2F100_1632.jpg&hash=644cf16396ba9abd7ea46a406b30ed4e)
![100_1631.jpg](/proxy.php?image=http%3A%2F%2Flh3.ggpht.com%2F_7TR0_ivhXKY%2FSvdxuW9KwoI%2FAAAAAAAAHSc%2FxIRJy0YfMBw%2Fs400%2F100_1631.jpg&hash=6e47a9121b6d2002a8e7b9ce22415617)
Thanks!