JwWright57
Well Known Member
Hi all, I'm at the point where I'm trial fitting the HS 1213 hinge brackets to the F1211 bearings and they are to tight. They fit when there are no washers included but too tight when there are washers installed. I'm at a loss about what to do about it.....
The brackets are square and the stops are not undersized. Everything seems good according to the plans but the fit is just a smidge to tight. I'm guessing that installing the stabilator after the emp cone is done would be a real pain if this fit is not "slide right in" tight.
Some pictures....
https://photos.app.goo.gl/SuIs8b6LlYjhSunf1
The brackets are square and the stops are not undersized. Everything seems good according to the plans but the fit is just a smidge to tight. I'm guessing that installing the stabilator after the emp cone is done would be a real pain if this fit is not "slide right in" tight.
Some pictures....
https://photos.app.goo.gl/SuIs8b6LlYjhSunf1
Last edited: