Hi,
There is a tooling hole in the W-631A aft canopy frame channel which rivets to the WD-725 side weldment. There is two holes that are opened up for a AN3 bolt that secures the canopy lug to the aft channel and side weldment (The two center holes in the picture below). The problem is there is a tooling hole in the aft channel just 1/8 to 1/4 away. This won't meet edge distance to the tooling hole. What has everyone else done?
Thanks
Vince
There is a tooling hole in the W-631A aft canopy frame channel which rivets to the WD-725 side weldment. There is two holes that are opened up for a AN3 bolt that secures the canopy lug to the aft channel and side weldment (The two center holes in the picture below). The problem is there is a tooling hole in the aft channel just 1/8 to 1/4 away. This won't meet edge distance to the tooling hole. What has everyone else done?
![1708721715494b0d64db4f2.jpg](/proxy.php?image=http%3A%2F%2Fwebsites.expercraft.com%2Fvinceb%2Fimages%2F1708721715494b0d64db4f2.jpg&hash=1d2a47dfba5ae122969d0f8d274fac2c)
Thanks
Vince