David Paule
Well Known Member
I needed something that would get in and let me buck the rivets on a nutplate that was in tight quarters recently. I looked around my shop for something and found a gear puller that I've had for a long time.
I had to dress the end but it did the job. Kind of light but adequate for this K1100-08 nutplate.
It's a Snap-On CJ66-1 and it's not on their site any more.
Although I think it would probably buck both rivets at the same time, I bucked the more accessible one with my usual bucking bar and used this for the one that was more difficult.
Dave
I had to dress the end but it did the job. Kind of light but adequate for this K1100-08 nutplate.
![im2tza.jpg](/proxy.php?image=http%3A%2F%2Fi58.tinypic.com%2Fim2tza.jpg&hash=3a2ba756103b964a4fc5216e7da5c679)
It's a Snap-On CJ66-1 and it's not on their site any more.
Although I think it would probably buck both rivets at the same time, I bucked the more accessible one with my usual bucking bar and used this for the one that was more difficult.
Dave