Tom Martin
Well Known Member
Here is a simple tool that I made to do some repetitive marking on the RV10 door window cutouts. This simple template takes minutes to make but can save a lot of measurements. It also removes measurement errors, which often happen when making repetitive marks using a ruler.
The small hole is where you place the pen, the large hole is so that you can see if you are actually making a mark. The large hole also helps to reduce the smudging that often occurs when dragging a pen in this kind of situation. The line helps you to visually keep the template 90 degrees to the surface. On this particular template I rounded the face so that it would go nicely around the smallest window radius.
Enjoy
The small hole is where you place the pen, the large hole is so that you can see if you are actually making a mark. The large hole also helps to reduce the smudging that often occurs when dragging a pen in this kind of situation. The line helps you to visually keep the template 90 degrees to the surface. On this particular template I rounded the face so that it would go nicely around the smallest window radius.
Enjoy
