Gregg Brightwell
Well Known Member
I fabricated a little bracket that holds a fine point sharpie great. Sharpie goes in the big hole, the tip goes through the little hole. Keeps it square, and dead center on a 5/8ths flange.
Also, here is my deburr tool. Deburr bit in a cordless screwdriver. I have seen other folks do this. I did not take the time to make an adapter. I used tape.![Big grin :D :D](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
http://i41.tinypic.com/rsc36h.jpg
Here, I took an old dull, 6 inch 40 bit and cut the threads off. Attached a flag, and Voila'... Rig pin
http://i41.tinypic.com/2w50lz9.jpg
Happy building,
Gregg
Also, here is my deburr tool. Deburr bit in a cordless screwdriver. I have seen other folks do this. I did not take the time to make an adapter. I used tape.
http://i41.tinypic.com/rsc36h.jpg
Here, I took an old dull, 6 inch 40 bit and cut the threads off. Attached a flag, and Voila'... Rig pin
http://i41.tinypic.com/2w50lz9.jpg
Happy building,
Gregg